MyoWare 2.0 Cable Shield - Non-Wearable Project Connector - On-Board snap connectors - 3.5mm TRS Jack Attach a Traditional Three-Electrode Sensor Cable - Board Dimensions: 1.48in x 1.41in

Detalles del producto

Disponibilidad
En stock

Peso con empaque
0.20 kg

Devolución
Si

Condición
Nuevo

Producto de
Amazon

Viaja desde
USA

Sobre este producto

MyoWare 2.0 Muscle Sensor Form Factor: 3x Male Snap Pins (Input Electrodes): Easily attach to other MyoWare boards; Snap to bottom side of Muscle Sensor Board
1x 3.5 mm TRS Connector: Attach traditional 3 electrode sensor cable; Test and use muscle sensor without attaching board to a person
Board Dimensions: 37.57 mm x 35.90 mm (1.48 in x 1.41 in); Note: Accessory only; MyoWare 2.0 Muscle Sensor will need to be purchased separately
Use with non-wearable projects: Projects housed in an enclosure or that target muscles that are too small or situated such that the on-board electrode sockets would not be suitable
Note: MyoWare and the Cable Shield are not intended for use in the diagnosis of disease or other conditions, or in the cure, mitigation treatment, or prevention of disease, in a man or other animals